Chuckaroo's
Laser Engraving®
BUTT STOCKS
We cannot laser engrave (etch) guns with a blued or Parkerized finish.
Stocks must be less than 25 inches in length to
fit in the machine.
Make Your Henry Extra Special Or Turn It Into A Family Heirloom |
Grips, stocks, forearms all beg to be engraved. The cost for grip work depends on the amount of preparation needed and the complexity of the design. The pictured grips are in the $45 to $90 range. Prices do not include shipping and insurance. Modifications to the makeup of the patterns may required additional set up fees. We cannot laser over existing checkering or a previous engraving. The curvature of the surface may limit how close we can get to the outer edge of the work piece.
Engraving on Wood - Laser engraving
wood is always interesting. Every species of wood is different and so are
the results when laser engraved. Wood density, species, wood stains and
the finish on the wood all create variances in the final outcome. Because
of this, there is no way to guarantee that one engraving will resemble another.
Softer woods don't burn and usually don't give a dark look. Hardwoods, like oak,
will give a textured appearance. The lighter the wood color, the greater
the contrast and in most cases, the lighter wood displays the engraving better.
This is why we use alder wood for our plaques. Dark walnut engraves fine
but the visual contrast is not as vibrant as with lighter wood shades.
The pictured forearms and stocks are in the $35 to $90 range.
Modifications to the makeup of the patterns may require additional set up
fees. We cannot go over existing checkering or a previous engravings.
The curvature of the surface may limit how close we can get to the outer
edge of the work piece.
We can combine or alter any of the samples below. They are a small display
of customers requests.
The CO2 laser cuts straight up and down and does not put an
angle on traditional type checkering. Stars, on the other hand, are very
popular and provide a superior grip. Fees do not include shipping and
insurance. Prices do
not include the removal or replacement of the wood from the gun. We cannot
engrave metal with a blued finish. It must be stainless steel, coated metal,
anodized aluminum or uncoated brass.
All pricing quotes are for standard materials and limited graphic work. Composite, laminated woods, horn, antler,
bone and exotic materials may be slightly higher.
Some complex designs may require a
small set up fee. If you reuse a design that you have already ordered in the
past, there would be no set up charges. We do not use jigs for set up.
Each stock or forearm is started from scratch. First time designs may require a
small set up fee. If you reuse a design that you have already ordered in the
past, there would be no set up charges.
Some logos or graphics,
provided by the customer, are not useable in their original condition.
Lasers need a good line drawing for the best results. Many graphics can
be converted and made usable. Some are just not good enough to convert. At times,
graphic redesigns, can require several hours
of extra work and a graphic conversion fee may be necessary. The
ideal graphic is a vectorized line drawing preferably in Corel draw.
|
||||||||||||||||||||||||||||||||||||||||||||||||||